number of solder points
200 - 100 000
Asssembly time from
1 day
High
soldering quality
Mounting from
1 Board
Express
delivery
Perform urgent small-scale assembly of printed circuit boards
number of solder points
200 - 100 000
Assembly time
1 - 5 days
It involves installing components on the surface of the Board by soldering the SMD (surface mounted device) component to the contact pad.
this type of installation allows you to place components not only on one side of the printed circuit Board (single-sided boards), but also on both sides (double-sided boards).
1
2
3
4
5
6
7
8
9
10
This method of fixing elements on the board has advantages and disadvantages:
Advantages of manual soldering:
• High quality fixation of each electronic components
• Avoid the defects, which occur sometimes when using semi-automatic equipment.
• Possibility of soldering the element leads through holes on the board.
• Avoid the damage of components, that caused by incorrect soldering temperature settings.
• The ability to fix on the board components of different shapes and sizes.
• Long time to create PCB compared to automated production.
• An expensive service, which need to pay for one or a team of qualified engineers.
• High cost of the finished chip.
The use of manual soldering leads to better result. An experienced specialist has the necessary knowledge and skills for soldering boards, so he can avoid the machine defect. However, creating chips by hand takes more time than automated production and also more cost. As a result, the time of manufacture of board, as well as their cost increase.
When PCB manual assembly is used:
In the manufacture of microchips ,fixing elements on the plate is carried out by special machines for assembly. The following components are usually mounted by hand:• Non-standard surface
• The leads
If the boards needs to install one or two chips in non-standard sizes and shapes, the use of semi-automatic equipment is inappropriate. It requires a special configuration or manual installation. Fixation of DIP-elements in 95% of cases is carried out by hand.
The contact leads of components are soldered through holes which drilled and metallized. There are workstations for SMD and DIP soldering. However, the gradual loss for importance of “Thru-hole” Soldering, has made them inapplicable. Nowadays, the leads of elements are fixed manually using soldering iron.
How to order PCB manual soldering:
Soldering of chips must be performed by a qualified specialist. Perform the work by inexperienced engineer can make a single components or the whole board unusable. As a result production of chip is more expensive and takes more time, so you need to contact with a specialized center for PCB production-SOLDER POINT company- your key for high quality manual assembly of electronic models and a guarantee for all the performed work.
